Embedded Systems Applications
Project description
Embedded Systems Applications
Sequence Generator
Assessment Details:
The assessment exercise is to design prove operation and produce the necessary data for manufacture of a high-speed radio identification system. When the lifejacket
to which it is attached is wet it should begin transmitting if switched ON.
The system is to transmit the following message:
MAYDAY [2 spaces]EMERGENCY [2 spaces] MAYDAY [Space 5 secs then repeat]
Spaces should be included in the transmission. The data should be transmitted as ASCII code in a parallel manner.
Dry or Wet
OUTPUTS x8
4 Hz or 2 Hz
On/Off
Should switch on only when WET and ON signals are ‘1’.
A transmission frequency of approximately 8or 4characters per second depending on speed control input.
Every 40 sec the system should stop transmitting for 10 sec. Energy efficiency is important.
Hardware
The solution should be simulated using the easy8051B development boards programmed in MC51 assembly language using the µVision software.
Assessment Criteria:
You should present a report on the development of your solution with certain key elements
1. Clear description of the methodology you are using to implement the system. A flow chart or Pseudo English description of the way in which you are solving the
problem.
2. A clear well documented program which follows a logical process and is based on the solution in Section 1.
3. A clear test strategy should be identified.
4. An evaluation of the design in terms of areas of weakness and possible improvements which could be built in.
The working solution should be demonstrated to the Module Leader.
The assessment will be marked as follows:
Presentation of Report 15%
Development of Solution 30%
Design of Program 30%
Evaluation and Analysis 20%
Demonstration of Program 5%
Assessment Type: Coursework
Final Module Mark Weighting: 25%
Assessment Limits: 2000 words
Submission Date: Click here to enter a date.
Submission Method: Via School of Engineering Office, E33
Tutor with Direct Responsibility:
Standard Instructions to Students:
1. Your work must be submitted with the appropriatecover sheet which must confirm that the assignment work is your own.
2. You are advised to keep a copy of your assessment solutions.
3. Late submissions will be penalised following the University guidelines as follows:
a. Up to 5 working days late maximum mark 40% or P1
b. After 5 working days no mark will be awarded.
4. Extensions to the submission date may only be given by the Module Leader for exceptional circumstances.
5. The University rules on Plagiarism will apply to all submissions.
6. Work will normally be returned within THREE WEEKS from the date of submission.
PLACE THIS ORDER OR A SIMILAR ORDER WITH US TODAY AND GET AN AMAZING DISCOUNT 🙂